How do I make sabertooth teeth for HiveWire Tiger for Daz3D?

[Sasa]

Hello everyone, I am here to request add on how to properly sculp sabertooth teeth I can scale a bit size wise for the product HiveWire Tiger located here: HiveWire Tiger 3D Figure Assets 3D Models HiveWire3D I am hoping it will look something like this: © National Geographic Thank you for reading!

 

[3WC]

Saber Tooth morph for HW Big Cat

How's this?

 

[DanaTA]

Saber Tooth morph for HW Big Cat

How's this?

View attachment 76998

They look a little thin. I think they'd break off and he'd have a hell of a toothache! They should get thicker towards the gums.

Dana

 

[DanaTA]

Smilodon Fatalis.

Dana

 

[Sasa]

They look a little thin. I think they'd break off and he'd have a hell of a toothache! They should get thicker towards the gums.

Dana

Yeah, I was thinking the same haha. I tried extending the teeth on the tiger itself but its too thin and also gets all bent out of shape.

 

[Stezza]

I use Carrara but same can be done if you use DS to export to Hexagon and resize the needed teeth and then send back to DS as a morph.. I think..

 

[DanaTA]

The tiger would need some modification, though, to be more accurate. Though called a tiger, the saber tooth was not really a tiger or even a cat. They say it was more closely related to a bear. But not really that, either.

Dana

 

[Sasa]

I use Carrara but same can be done if you use DS to export to Hexagon and resize the needed teeth and then send back to DS as a morph.. I think..

View attachment 77004

I am not quite sure how any of that works. (⁠;⁠ŏ⁠﹏⁠ŏ⁠)

The tiger would need some modification, though, to be more accurate. Though called a tiger, the saber tooth was not really a tiger or even a cat. They say it was more closely related to a bear. But not really that, either.

Dana

I know, this is more if a fantasy saber and not fully based off of a single species. Its more of a mix between a Smilodon X Siberian tiger type of build/character.

 

[Stezza]

or you can just model something to suit

 

[3WC]

Well, the morph for the teeth only took me about a 1/2 hour in blender, as a proof of concept. I could make another morph to thicken them up. But, do you want a fish, or do you want to learn how to fish...?

 

[3WC]

Daz Studio - Thicker sabers for HiveWire Big Cat

 

[Sasa]

Daz Studio - Thicker sabers for HiveWire Big Cat

Thank you so much!! I apologize for the very late reply, I was in the hospital for a bit. I will try this out asap when I am able to go on my PC!