• Welcome to the Community Forums at HiveWire 3D! Please note that the user name you choose for our forum will be displayed to the public. Our store was closed as January 4, 2021. You can find HiveWire 3D and Lisa's Botanicals products, as well as many of our Contributing Artists, at Renderosity. This thread lists where many are now selling their products. Renderosity is generously putting products which were purchased at HiveWire 3D and are now sold at their store into customer accounts by gifting them. This is not an overnight process so please be patient, if you have already emailed them about this. If you have NOT emailed them, please see the 2nd post in this thread for instructions on what you need to do

Poser Pro 11 will not start up.

I have been using PP11 without issue since it came out. Last night my windows 10 install updated and now PP11 will not start up. I click on it get the little blue swirly for a second or two and then nothing. I turned off windows firewall, rebooted a half dozen times, and ran as admin still no joy. Has anyone run into this and have a solution? I am going to try the support site for Smithmicro but for whatever reason I no longer have an account there so it is not going well.
 

Alisa

RETIRED HW3D QAV Director (QAV Queen Bee)
Staff member
QAV-BEE
Hmm.. I know there were some issues with Windows 10 (a security update) and PP2014 which I believe are resolved.

I was going to suggest you ask in the official Poser forum at RDNA, but I see you already did. If you find any answers, please post to let folks know.

Good luck!!
 
Top